Table of Contents

ESA Summer of Code in Space 2016 - Idea List

Bolidozor is open-source hardware and open-source software project which is focused on radar detection of airspace and astronomy objects. The Czech Astronomical Society partially support this project by donating a storage space for our data. We want to improve our data-mining abilities by software development supported by European Space Agency.

Main goals

  1. Design algorithms and implement innovative technologies for astronomy observations in existed radio detection network.
  2. Extend existing system for collaboration of people in science in whole EU region.

Bolidozor project is meteor bolide detection network equipped by several types of radio detection stations. RMDS02D and its predecessor RMDS01 is a SDR receiver system designed primarily for radio detection of meteor trails. It's advantage over other designs is a high performance software defined receiver and completely open-source design, which brings advanced signal processing of radio images for everyone. This system now has several detection stations (see the map) in the Czech Republic and Slovakia. But technically it could be extended to other European countries.

Radio Meteor Detection Station RMDS02D

Tasks for SOCIS participants

The list is ordered by task priority. There are brief description of problems and description of initial task for qualifying of you for these SOCIS tasks. If you are interested in the tasks presented here please do not hesitate to contact us at bolidozor@googlegroups.com, we will explain you a technical details.

Calculation of meteor trajectory from multiple station recordings

The Bolidozor network currently has an ability to observe one meteor by multiple radio stations. The signal parameters are different to the each station. The signal differences at multiple stations could be used to obtain guess of the observed meteor trajectory.

Qualification task

Because the task is an sort of special optimization problem. The student has to show its abilities of dealing with general optimization problems by creating an algorithm which could optimize geometric parameters of an antenna to match a given impedance at given frequency.

Project details

The algorithm which allows calculation of meteor trajectory from multiple reflections is partially known. Unfortunately it is very computationally intensive even with small number of stations, therefore its redesign is needed.

Expected results

A working utility which takes set of meteor reflection parameters and returns the most probable trajectory of the meteor with given reflection.

Radio Meteor Interferometry

The radio meteor detection station RMDS02D could be run simultaneously in multiple instances on one site. Therefore this station has abilities for radio interferometry detection of meteor trails with use of an antenna array at observatory site. The software for computation of heading to the meteor from multiple records taken in same time with RMDS02D from two or more antennas.

Qualification task

The student has to create a GNUradio based interferometer which could determine the source direction of radio signal from an antenna array. The algorithm must involve noise mitigation and possible phase errors from antenna array.

Project details

With use of interferometry the direction of target object can be discovered. We intended to use multiple RAW radio meteor reflection records for determine of direction to reflection. The radio-observer application has to be extended for simultaneous recording of multiple signals from multiple radios with synchronised Local Oscillator or radio-observer's functionality must be reimplemented to the GNUradio. These two approaches can be used for calculation of correlation. Finally the direction of reflected signal will be found from antenna array phase correlation. Student helps community with acquisition of another information from meteor trails records.

Expected results

The application on GNUradio schematics for GNU/Linux operating system which determine direction to the reflection from measuring station. Some limited user interaction is possible.

Contact

For further information we strongly recommend to contact the project coordinator.