Differences

This shows you the differences between two versions of the page.

--- en:faq [2019/05/01 09:59] – [What computer will I need?] fluktuacia
+++ en:faq [2019/05/01 10:05] – [What do I have to do in order to relocate the station] fluktuacia
@@ Line 7: / Line 7: @@
 You will only need another computer if you want to [[en:vizualizace|visualisee the data]] at other place than the one with a station (e.g. in a lecture room). In that case you mainly need a computer with a graphic performance corresponding to the planned quality of visualised output.
-==== What do I have to do in order to relocate the station ====
+==== What do I have to do in order to relocate a station ====
-Before moving the station or disconnecting the antenna it is necessary to turn the station off and mainly to unplug the power supply.
+Before moving a station or disconnecting an antenna it is necessary to turn the station off and mainly to unplug the power supply.
-The station has one switch on module with connected power supply. This switch has to be pressed. Than it is possible to disconnect antennae and further manipulate with the station.
+The station has one switch on a module with connected power supply. This switch has to be pressed. Then it is possible to disconnect antennae and further manipulate with the station.
-After moving the station it has to be turned on again and wait several minutes until it the blue LED on the station’s computer starts to flash again. If the LED does not flash even after several minutes, the file system of the station has been damaged.
+After moving the station it has to be turned on again and wait several minutes until the blue LED on the station’s computer starts to flash again. If the LED does not flash even after several minutes, the file system on the station has been damaged.
 === LED on the power module is not working ===