Differences

This shows you the differences between two versions of the page.

--- en:image-c2 [2019/03/04 07:21] – fluktuacia
+++ en:image-c2 [2019/03/05 13:42] (current) – fluktuacia
@@ Line 28: / Line 28: @@
   $ sudo python setup.py develop
-In case of Odroid-C2, I²C has to be made work by a correct entry into ''/etc/modules'', as described at [[http://wiki.mlab.cz/doku.php?id=cs:odroid-u3#I%C2%B2C%20na%20odroid-U3|MLAB wiki]]
+In case of Odroid-C2, I²C has to be made work by a correct entry into ''/etc/modules'', as described at [[http://wiki.mlab.cz/doku.php?id=en:odroid-u3#I%C2%B2C%20na%20odroid-U3|MLAB wiki]].
 ===== station-supervisor =====
@@ Line 133: / Line 133: @@
 Testing the synchronisation can be done following these [[http://wiki.mlab.cz/doku.php?id=cs:time_sync|instructions]].
-===== Getting an SDcart ready =====
+===== Getting an SD card ready =====
 A new SD card has to be formatted to [[https://en.wikipedia.org/wiki/F2FS|F2FS]] file system. In order to do it, you have to install a support for F2FS file system into your OS.
@@ Line 167: / Line 167: @@
 </WRAP>
-It is also necessary to add to ’’/etc/rc.local'' what has to be launched after startup. All stations should launch ''/home/odroid/repos/station-supervisor/start.sh'' - this will run the station’s software. Because the station’s software should run under  ''odroid'' user, the whole command should look like as follows:
+It is also necessary to add to ''/etc/rc.local'' what has to be launched after startup. All stations should launch ''/home/odroid/repos/station-supervisor/start.sh'' - this will run the station’s software. Because the station’s software should run under  ''odroid'' user, the whole command should look like as follows:
   su odroid /home/odroid/repos/station-supervisor/start.sh